What Are The Problems When Using Steel Bridges? Manufacturers Answer Questions
Dec 13, 2021
As an intelligent weak current system, steel bridge manufacturers play an important role in our usual lives. However, it will often show some problems and cause confusion in our lives. So do we know what problems the cable tray will have?
1. Possible faults: All parts of the cable appear to be short-circuited. Such faults may form the current relay operation on the power distribution cabinet, and the damage to the cable is very serious;
2. Defects that will appear: There is a short circuit inside the cable, which is usually caused by the low quality of the cable, and there will be no traces on the outside;
3. It may appear that the entire cable is burned or a certain part of the cable is burned, so that the cable is damaged very severely at the faulty place;
4. The fault that may appear is that there is only one short circuit in the cable tray, and the cable at the fault location is slightly damaged, but there are still obvious traces.
This kind of fault may appear because the current is too large or the cable quality is too poor.
All mechanical equipment must be inspected and maintained regularly after use. Cable tray manufacturers will talk about how to overhaul and maintain cable tray equipment.
1. Test and check the operation status of the balance cylinder of the cable bridge equipment and the oil circuit and joints of the oil lubrication system.
2. The friction between the slider and the guide rail of the cable bridge equipment is relatively frequent, and necessary adjustments should be made to check the lubrication quality of the joints and the pipeline to ensure good operation.
3. Regularly lubricate the gear parts of the cable bridge equipment: the gear transmission box and internal parts are more likely to be damaged due to frequent operation, and the possibility of loosening is greater.
